Autocad 2013 car tutorial

Draw a line from the end point of this new arc, and connect to the point of the arc at the left of the screen until you get something like this. Using the fillet tool connect the arc created at step 11 with the arc created at step but choose the fillet radius as Do the same for the upper of the arc created at step 11, with a radius of The final step is by using the fillet command to get an arc between the circle created at step 20 with the outer arc created at step 17 with fillet radius as Did you make this project?

Share it with us! I Made It! Remote Control Light Switch by alanmerritt in Arduino. Kulvinder Singh Bhatt 2 years ago on Introduction. Reply Upvote. Answer Upvote. Swansong 5 years ago. I used random dimensions. I want to explain the commands and the way to make an engine.

You can use your dimensions. FILE: V12 engine. That would be really helpful if you continue the tutorial on how to make engine. Thanks Aykut! Dear all one thing I can not understand here you have drawn one hole worth 5 mm here after than you have drawn 7mm hole and both the holes has been extrude cut through out from their so you have shown both holes in drawings so how it is possible?? V12 engine. Thanks to Grabby :. Other than that , thank you very much I'm using this to get some knowledge about combustion motors as I'll be introduced to them in a couple months in thermodynamics II.

Hello aykut, are there any drawing files of the dimensions? I want to make an engine. Thank you. Props to the tutor.

Gret tutorial!!. I look forward to the day when I can share one with fellow students of solidworks. Very nice tutorial so far after i enjoyed creating the first part, I assume the last fillet around the edge of the connecting rod was 0.

The filleting part is confusing. The given file mentions something else compared to the tutorial First of all big thanks for this extraordinary tutorial, it helps me my graduated project.

Now I would like type a couple of turkish words. Thank you for all of this tutorials. I'll try to all understand but that's not quite simple as I'm a french personn.

I imagine there a not tutorials in french. Don' worry I better understand than I write :D. Thanks Aykut. The tutorial is pretty helpful. I made an Alibre Design version of this connecting rod.

Well done Aykut. Very detailed tutorial. I am encouraging you to prepare other tutorials for Sheet Metal an for Welding for example.. These tutorials look great and are detailed. See Figure 6. See Figure 8. You can also load files in your computer. See Figure 9. Figure 9 highlightes the Back button. Figure 10 highlightes the Forward button. Figure 11 highlightes the Up button. Figure 12 highlightes the Search button. Figure 14 shows the Favorites folder.